Fiat 500 Replacement Key Fob
If your remote key fob isn't working, it may be time to replace the battery. If you do replace the battery and it does not work it is probably elsewhere.
United Locksmith specializes in the creation of new keys for classic cars. We have the tools and spare parts required for this type of service.
Dead Coin Battery
A dead battery is the most frequent reason for your Fiat 500 keyfob not locking or unlocking the doors. The battery for the coin cell in the key fob will drain quickly in the event that you don't use frequently enough. If your remote began to show signs of weakness such as a loss in range and then completely stopped working, the battery is probably dead.
The battery in the key fob is secured by metal clips that hold it in place. If the clips aren't secure, they can cause contact issues that will stop your remote from receiving power. With a small flathead screwdriver, pry the clip that holds the retaining pin open to remove the current battery and replace it with a new one. Make sure to use a battery with the same voltage, size, and specification as the original.
The key fob could also become corroded or damaged by water exposure. Even a quick bath in soapy water may damage the electronic chip inside. Make sure your key fob is dry.
Water Damage
If your key fob isn't functioning properly, it may be caused by water damage. The rubber seals on key fobs stop them from getting damaged by a light splash or drizzle of water. However, it is essential to keep the keys of your car away from the washing machine, the ocean, and pool.
The key fob has an electronic chip that transmits a signal to your car's immobilizer system. The chip allows the 500 to lock and start. If it gets wet, it will no longer work.
You can try cleaning the internal electronics of your key fob with isopropyl Alcohol or an electronic cleaner to see whether they're still functioning. It is best to replace the key fob if it has been submerged into salt water, rather than trying to repair it yourself.
A replacement fob can cost you a few dollars, but it's a lot cheaper than having to have your Fiat 500 towed to a dealership and fixed there! You can also do it yourself by following a few simple steps. Just make sure you have the correct battery type before you attempt to open your key fob. fiat doblo key fob replacement can find step-bystep instructions for every car keyfob online.
Faulty Chip
The chip in the key fob communicates directly with the immobiliser of your vehicle to ensure that the vehicle will only start once the correct keys are inserted. If the chip is damaged or corrupted in any way it will not start.
Water damage or a dead cell battery are the most common reasons for defective chips. Regardless of the reason, it's recommended to delegate this work to a locksmith, as they will be able to replace the chip fast and at a reasonable cost.
If your key fob ceases to function after exposure to clean water from the tap or rain, take out the battery and clean the electronic component with a tissue to ensure it's completely dry before putting it back into. If the key fob still isn't working it's probably to be a damaged chip and will require replacement.
Some people go to their dealer if they require an entirely new Fiat fob. However, this could be expensive. United Locksmith is the best place to go if you need your Fiat keyfob fixed at a reasonable cost. We have all the tools and knowledge required to repair your Fiat fob in a professional and timely way.
Faulty Receiver Module
Fiat key fobs send a signal up 50 feet to the vehicle, which will open and close the doors (and start the vehicle if it has automatic transmissions). There are many reasons why a fob could not function. These include a dead coin battery, water damage buttons, worn ones as well as a receiver module problem, and signal interference or an electronic chip that has failed.
If the fob was in a pocket which has experienced extreme trauma, such as being dropped on hard floor or getting washed in a washer and it isn't capable of communicating with the car's Body Control Module (BCM). The BCM is a security system which will only accept signals from genuine keys.
If this is the case, then you must replace your fob. A professional locksmith can handle every aspect of the replacement process and can even program a brand new one for the 500. They can even provide you with a clone fob that works just like the original (and costs one-third of the price).